PlanetZ forums - scopeusers.com

Hi

Every time I try to install the Pulsar 3 or 3.01 driver under WinXP Home... Pow. PC reboots without notice. Out of about 6 or 8 tries one time it didn't reboot (don't ask what was different) but on installing Pulsar s/w the driver wasn't recognised.
It's a completely fresh XP install with no other apps. I've just reinstalled XP in a new partition and still have the problem.
It's a Pulsar II and runs ok under Win98SE dual boot.
Pentium II 350MHz
576MB RAM

Any ideas?


<font size=-1>[ This Message was edited by: doodyrh on 2001-11-07 13:39 ]</font>

Which motherboard? Seen like a bad PCI slot choice for your Pulsar, try moving it.

Spot on Marcuspocus.
It was in the middle, now it's on the end. Dunno if it's 1 or 3 but it works.
Thanks for your help.

Go back to 98SE...
XP is not a good system for pro audio...

Well now that I found a work-around for a latency correlation problem in Sonar, _for me_, XP works better than any Windows o/s before... ie. lower latency, more accurate timing, better stability, etc. etc...

Toni L.
http://www.mp3.com/NativeAlien

It's Ok Analog. I'm not a Pro.
XP is fast and reliable. I'm sticking with it.

Well...
Tahts actualy the most importent thing...
If its work fine for you than stay
with it...

For me, 98SE is the best system...