PlanetZ forums - scopeusers.com

Hello,
I have a question to ask:
I have two cards pulsar installed on my DAW
(with the cable S-TDM for a total of 10 dsp).
Now I want to install a third card "pulsar xtc pro".
1-I can use a single cable with three connectors S-TDM ?
2-installing the new card "pulsar xtc pro" I could use a total of 16 dsp? (4 +6 +6) ?
3-"xtc pulsar pro" is compatible with s / c scope v5.1 ?

thank you very much for your attention.
gigisound

yes that is fine for sc5.1

thank you very much for your reply.

gigisound

hello,
someone can tell me if it is possible to remove the "classic 20 I / O plate" from the "Pulsar XTC pro" so as to use only the DSP?
It held together to the main board with the plastic rivets.

thank you very much for your availability and expertise
gigisound

yes it is ok but you will lose the adat ports and midi and spdif and analog i/o

it will then be just a booster 6dsp card

thank you very much for your reply.

gigisound