Wave drivers at 96kHz problem Solved
Posted: Sat Jan 04, 2014 6:27 pm
Well, i had problems in win 7 32bit and a Xite, with the wave driver that didin't worked in 96kHz.
How i solved that: In the sound properties at the control panel i selected the "speakers-scope xite-1" (the second with the same name in the list). Now when i clicked properties, it always appeared two tabs, "general" and "levels". But when i clicked right click->test and after that properties then it showed three pads! "general", "levels" and "advanced". So in the advanced pad i selected the 16bit, 96kHz selection and after that i could use the wave source at 96.
Another thing was that the wave destination didn't worked in 96kHz. (even with the previous tip applied).
But i found in reaper that when i select the wdm kernel streaming mode, it works fine! (i use that as an oscilloscope in parallel with wavelab in asio)
That's it
How i solved that: In the sound properties at the control panel i selected the "speakers-scope xite-1" (the second with the same name in the list). Now when i clicked properties, it always appeared two tabs, "general" and "levels". But when i clicked right click->test and after that properties then it showed three pads! "general", "levels" and "advanced". So in the advanced pad i selected the 16bit, 96kHz selection and after that i could use the wave source at 96.
Another thing was that the wave destination didn't worked in 96kHz. (even with the previous tip applied).
But i found in reaper that when i select the wdm kernel streaming mode, it works fine! (i use that as an oscilloscope in parallel with wavelab in asio)
That's it