PlanetZ forums - scopeusers.com

Hello I need to work on an 8k mono wav file , in cubase / wavelab .
Is there a wordclock generator that will put out an 8k clock signal I can run in to Scope Syncplate via bnc ?
I need to work at 8k for this audio , upsampling creates too many artifacts .
Regards , Michael

If you don't need scope for the project you could just use another driver that would enable you to run cubase at 8k.

Thanks Petal yes been thinking that . I'll use an old laptop etc . Cheers.

no need to use an old laptop, just change the audiodriver in cubase in your existing system

yes of course I just realised that thanks .