Page 1 of 1
Posted: Fri Jan 19, 2001 12:34 pm
by Guest
Hi
I cant get it to work, isnt the Asio suppossed to "send" the audio channels to the pulsar mixer (asio src) from cubase, IF i can open Cubase.
Coz now i cant even open Cubase.
what im i suppose to do?
Hilfe/help
mike
Posted: Fri Jan 19, 2001 12:52 pm
by Guest
Subject: cubase
you didn't mentioned which cubase version , anyway you should configure your asio drivers in cubase , i'll refer to 3.7 vst but generally it should work in any version :
get into audio -> system -> audio i/o -> asio device choose asio scope , click ok and it should work.
good luck
Posted: Fri Jan 19, 2001 1:05 pm
by Guest
Subject: cubase to P2
i've done that. when i can open cubase.
but it doessent work.
mike
Posted: Fri Jan 19, 2001 1:19 pm
by Guest
Subject: cubase
let me get this strate , the audio channel is a channel that you recorded from pulsar ? and if you did , is it really recorded (waves in the part) or just a clear part like a midi one ? , did you succeed to record from pulsar to cubase via asio ? that is important to know to help me figure the whole problem , anyway if i won't able to help you (but i'll try...) you can try post an article at:
www.cubase.net forum they have been very helpful to me in my first steps.
Posted: Fri Jan 19, 2001 1:47 pm
by Guest
Subject: Cu to P2
i have not recorded thrue the pulsar.
ive just installed the pulsar 2.04 and im trying to listen to an old recording, but i cant.
and now i cant even open cubase anymore.
5.0 ive got, maby i should try 3.7?
mike
Posted: Fri Jan 19, 2001 1:56 pm
by Guest
Subject: cu to p2
call me old fashion but i'm still using the good old 3.7 , works great for me.
Posted: Sat Jan 20, 2001 11:51 am
by Guest
Subject: Cu to P2
i think ive got it working now.
but.
is there any way of master the mix to 2tracks without "recording" it to Wavelab?
just like U do in cubase without the pulsar.
but now thru pulsar with pulsar Fx.
mike
Posted: Sat Jan 20, 2001 2:26 pm
by Guest
Subject: Re: Cu to P2
no.