Page 1 of 1
Simultaneous use of external spdif and ADAT converters
Posted: Sun Apr 15, 2012 2:57 pm
by sodiumcycle
I am using an 2-channel AD and an 8 channel ad/da with Luna2 + Pulsar setup. The 2-channel AD can only send clock over SPDIF but not receive. Is there a way to 'forward' clock signal to the ADAT converter when clocking off the 2-channel A/D? Thanks
Re: Simultaneous use of external spdif and ADAT converters
Posted: Sun Apr 15, 2012 3:22 pm
by garyb
sure, if the ADAT device has inputs too. you'll need to connect inputs(output fro the Scope card) and have the device slave to ADAT.
Re: Simultaneous use of external spdif and ADAT converters
Posted: Wed Apr 18, 2012 12:35 pm
by sodiumcycle
garyb wrote:sure, if the ADAT device has inputs too. you'll need to connect inputs(output fro the Scope card) and have the device slave to ADAT.
Thanks. This will simplify my setup.
Re: Simultaneous use of external spdif and ADAT converters
Posted: Wed Apr 18, 2012 12:36 pm
by garyb
