Page 1 of 1
Any way to modify existing module graphics?
Posted: Thu Jan 26, 2012 12:50 pm
by hegeldas
Hello, i am waiting for a pulsar 2 and i would like to use moduar, for the moment, i would like to know if it s possible to redraw modular modules graphics? and if someone know how it s possible to built completly new modules,
Thanks
Re: Any way to modify existing module graphics?
Posted: Thu Jan 26, 2012 2:00 pm
by YISH313z
I believe you would need the SDK to do as you seek.
Re: Any way to modify existing module graphics?
Posted: Thu Jan 26, 2012 3:23 pm
by HUROLURA
So far, the SDK is necessary for that purpose and also the knowledge about how to achieve that ...
Moreover, is is not that obvious/possible to modify existing modular modules but it is possible to rebuild some existing module from scratch to provide them with a different GUI.
From what I understood, the Scope 6 / Open Scope solution would provide some mean to modify existing devices GUI.
But the device would have to be rebuilt for that to allow such flexibility.
Then, the Modular would probably be a little more complex...
Re: Any way to modify existing module graphics?
Posted: Sun May 06, 2012 8:00 pm
by Chisel