PlanetZ forums - scopeusers.com

guys maby iam wrong but it is possible to connect a cd player with spdif fiberoptic to the fiberoptic i/o of the back of the pulsar

what device need i to load in to the system ?

As of Pulsar V3, it is now possible to use the ADAT port as a switchable Optical SPDIF!

I believe you do this in the "Sample Rate Settings" dialog box, switch to Optical SPDIF, then the signal is duplicated from SPDIF Coax output, also to the first ADAT ports.

is it "either/or"? (no, not kierkagaard).
I mean can I use one as spdif and the other as ADAT? I suspect not . . .

but can i record a digital cd player by optical in the adat a-input

then i open device sp dif input ( and there my signal from the cd player ??)

because i did that but i have no signal...

its a pulsar 2

Check your Master/Slave settings.

dubhuman can u try it your self and see if it works because i cant get it running i checked everything , new cables and even the manual !!!!

its not working overhere

once again what i did "


sony cd player optical out

in the adat a optical in

set in the samplerate window to optical

open the device spdif in and patch it to my analog outputs.

But there is no sound going into the system ,
i hate it ,if i cant get it running....

So if u could check it , i know if iam doing it wrong or there is a buggie

Thankz in advance !

Ronald Meij.

sorrie iam ttping in a dark studio

its SUBHUMAN...........

in the adat a optical in
open the device spdif in
-make sure you're using the 'new' optical spdif module-
and patch it to my analog outputs.
-ok-
set in the samplerate window to optical
-set sample rate to slave and choose correct input to slave to, with your cd on and connected with the correct module you will see the sample-rate appear as 44.1 in the sample-rate window, if you choose other inputs that have nothing connected to them while in the slave mode the sample-rate setting will switch to blank-