Page 1 of 1
Posted: Mon Oct 08, 2001 12:13 am
by Demon4ik
Hi DSP ppl. I`ve experied the following problems with my Pulsar v3 in windows XP. If someone have the same problems please confirm it here.
1.The seq.midi source modules must be loaded into the project before starting sequencer, or it won`t work.
2.In optical SPDIF mode no signal comes from optical out (sony MD connected)
3.In XTC mode midi inputs - outputs won`t work.
4.Winamp or win media player are working very bad. If trying to pause a playback pulsar trying to play buffer contents(effect of IRQ conflict on old ISA sound cards)
Posted: Mon Oct 08, 2001 5:42 am
by algorhythm
On 2001-10-08 01:13, Demon4ik wrote:
Hi DSP ppl. I`ve experied the following problems with my Pulsar v3 in windows XP. If someone have the same problems please confirm it here.
1.The seq.midi source modules must be loaded into the project before starting sequencer, or it won`t work.
that is not a bug, i do not think. you need a MIDI driver to run a sequencer!
2.In optical SPDIF mode no signal comes from optical out (sony MD connected)
with Pulsar I this is a known bug
4.Winamp or win media player are working very bad. If trying to pause a playback pulsar trying to play buffer contents(effect of IRQ conflict on old ISA sound cards)
are you using IRQ steering?
Posted: Wed Oct 10, 2001 12:31 am
by Demon4ik
Hello Algorhytm, thank You for the response
but nothing of Your ideas is right... The midi drivers are installed and from the sequencer You can see all 8 ports, but they are not working if Your project do not contents them before You start the sequencer, in other words You can`t add sequencer midi source than sequencer is running.
About IRQ. all my DSP cards are useng IRQ 5 without sharing it with other devices. I`ve tryed few different combinations but nothing helps.
Thank You anyway
Vadim N
Posted: Wed Oct 10, 2001 8:01 am
by subhuman
<i>in other words You can`t add sequencer midi source than sequencer is running. </i>
Yup - this is not a bug - you must have all drivers loaded into your project BEFORE starting your sequencer in Pulsar mode, or you will have to restart your sequencer so it finds them.
XTC mode is a different story though...