This forum has been silent for a long time not, so lets get things moving with a easy question for whoever knows the answer.
I am working on a device that has many pads exported named in1 - in32. On the device placed in the routing window I would see the midi in on the top left then in1 - in32 down the left side in order. But somehow in the process 2 pads got moved to the top so now I see in13 in24 then the midi followed by the remaining 20 ins down the left side. I don't know how I moved them so I cannot figure out how to reorganize the order.
The device works but the inputs being out of order will make routing in the routing window a pain. Anyone know how to move the pads around with out un-exporting them all and re-exporting them in order?
Thanks. Mark.
exported pad location
- roy thinnes
- Posts: 651
- Joined: Thu Jan 09, 2003 4:00 pm
- Location: Graz
- Contact:
Re: exported pad location
try this:
-select the pad which is not in the correct order
(next steps are valid for "in" pads placed on left side of the module)
-press "t" -> the pad will be on top of the module
-press "l" (lowercase L) -> pad will be on left side again and in the right order
-select the pad which is not in the correct order
(next steps are valid for "in" pads placed on left side of the module)
-press "t" -> the pad will be on top of the module
-press "l" (lowercase L) -> pad will be on left side again and in the right order
Re: exported pad location
Thanks for the reply, but that did not work. The t moved the pad to the top, the l moved it back to the same place on the left.
Mark
Mark
mark winger
Re: exported pad location
try "u" and "d", for up and down.... you may have to refresh the module itself to see the new arrangment (either do a "go inside, go back out, or long-click the module name to put it in edit mode and press enter to refresh the display.
Re: exported pad location
I did not know about the u and d key for up/down. I will try it.
Thanks.
Thanks.
mark winger