PlanetZ forums - scopeusers.com

Hi all.
I wonder if I can do the following setup:
Currently I am using RME FF400 sound card (Using FW), and I have a UAD card inside my DAW.
My Pulsar card runs on another computer and I connect the RME and Pulsar using ADAT.

Is it possible to install my Pulsar card in my DAW and work in XTC mode, The RME should remain the Master sound card.

Thank you
Tomer.

I can't help as far as xtc mode goes as I've never used it.

But I do have an rme fireface 400 running in the same computer as 2 scope pci cards and also had multiple UAD cards at the same time.

Currently I'm using scope asio in cubase and have the fireface synced via adat. I use the fireface for monitoring and all the analog inputs.

The only problem i have is that using rme digicheck at the same time as scope reverb causes playback to stutter in cubase.

If you need any help setting it up like that feel free to pm me

Thanks Andy, its a nice setup.