PlanetZ forums - scopeusers.com

Hi all
I am abroad with my 3 cards and I had to remove the cards. It is a 3 pci slot gigabyte mobo.

I have put them back in, now getting error msgs - whole set , from 'pci cannot communicate' to 'copyright violation' etc.

I read on Scope site, says don't use 1st or last pci slot - not much use to me as I have 3 cards, 3 slots - but I am not sure I am putting the interlink cable strip on right - it has a red edge.

The cards are 2 x Luna and 1 x 6 dsp P2. The P2 has a front (near outside i/o end) and rear (at back of card) connector.

I do not have the manual (back in UK) where it shows correct link up for this (not z link, this is the inter card strip).

Any tips welcome

Thanks

I hope this will help.
Installation manual:

http://www.electronicambient.de/mp3/chr ... lation.pdf

good luck

Thanks that is very helpful. The Scope site only has parts (chapters) of the manual.
Geoff