Page 1 of 1
insert fx position
Posted: Fri Jan 14, 2011 5:59 pm
by roy thinnes
hi there developer,
can you please help me out?
I can't get an insert fx to remember its position when loaded into an insert slot. It's ok when loaded into scope surface, but not as an insert.
It didn't help right-clicking Panel-SpecialPads-Position.
Can anyone give me a tip?
Re: insert fx position
Posted: Sat Jan 15, 2011 1:26 am
by tgstgs
does it remember in the screensets?
good vibes
Re: insert fx position
Posted: Sat Jan 15, 2011 6:08 am
by wolf
The position name/number of an insert fx is determined by the insert slot not the insert fx itself.
So either the insert slot passes over the value or it is not entered into the insert slot properties.
best,
Wolfgang
Re: insert fx position
Posted: Sat Jan 15, 2011 12:32 pm
by roy thinnes
thanks for your replies!
-tgstgs: no, I doesn't remember in screensets.
-wolf: I don't think it is a matter of the insert slot itself, because I loaded the fx device I made into a standard DynamicMixer insert slot.
Re: insert fx position
Posted: Sat Jan 15, 2011 2:19 pm
by tgstgs
put show posX posY pads in parameterslist (not presetslist!)
and select RP RS SP SS
the other deselect_
now it remembers at least in the screensets i guess that solve your probl too_
good vibes from vienna
Re: insert fx position
Posted: Sat Jan 15, 2011 2:55 pm
by roy thinnes
ok got it tgstgs. thanks a lot!
because in an empty Effect / Insert fx PresetParameterList there is no "posX" or "posY" , you have to select "Panel" in ProjectExplorer, then "Var", and then drag PosX and PosY to the PresetParameterList.
thankful vibes from Berlin
Re: insert fx position
Posted: Thu Jan 20, 2011 7:22 am
by wolf
oh, I misunderstood you completely
I thought you mean the position of the fx inside insert slots, not the screen position of the surface ..