PlanetZ forums - scopeusers.com

Hello fellow pulsarians,
At this moment no midi reaches my pulsar I with v 3.0 software, an Pulsar SRB and a XTC.
When i check the drivers in the control panel>System>Device manager all the drivers, Pulsar, pulsar 2 and SRB say they are working fine. When i check the midi setup in the control panel>Multimedia>Devices>'Midi devices and instruments' i'm told one of the Midi for Pulsar drivers (pulsar 2) is enabled but inactive due to an unknown problem. Same thing for the Midi for Pulsar SRB.

Repeated reintallation of the drivers doesn't help.
Can anyone give me any information on how to sovle this problem?

thanks,
Michaud

I had the same problem.
You have to set the ULLI settings to the slowest: 23ms.
Then "reload I/O" and it should work.

But I don't recommend using the XTC VSTi's right now until the "plugin delay compensation" and "exprt audio" bug is fixed.

Cheers,
Borislav.

Thanks but,
The ULLI setting was ion the lowest setting: 44KHz> 25 ms, and how do i reset the I/O?
grtz,
Michaud

Cubase:
Options -> Audio -> System...
ASIO Settings
"reload I/O"

That's it.