PlanetZ forums - scopeusers.com

I have not downloaded the manual yet, so i may been in error, but from what i can tell i can not put a signal out of the monitor outs. i have an adat line coming into channel 12, meters bumping, i turn on the monitor sends, page to the monitor faders and see the meters bumping but when i check the siganl inside soundforge for recording there is nothing there. (monitor outs connected to wave device destination which is where souundforge gets the signal) I can get the auxs, busses and control room to send a signal, but not the monitor outs.
Any info much appreciated

cheers JD

works for me,are you sure that you are connected to the monitor out and not the studio out?