PlanetZ forums - scopeusers.com

Posted: **Thu Sep 27, 2001 3:35 am**

1)I used same conect like V2.04 work with V3..but in V3,there is no signal from my DAT throgh AES/EBU(with slave mode)..no sound..
2)in my another system wth XP (final version),with standar PC not ACPI,but when I install V3-win2K driver..till "cwScopeProp.dll" show up..then all screen freeze..don't move anymore..then need to hard rest and just can't install..why?

My board is Pulsar I puls(AES/EUB version)

Regards

Jerry

[ This Message was edited by: jhstudio on 2001-09-27 04:36 ]

Posted: **Thu Sep 27, 2001 4:53 am**

This is a know bug of v3..We are waiting for the fix..J dont know when..Everybody with this prob must send a mail to creaware to make it hurry...

Posted: **Thu Sep 27, 2001 5:12 am**

Thanx..but install driver in XP is a bug too?
but I saw many ppl in the forum they did install v3 in XP already...
it's my problem?

Jerry

Posted: **Thu Sep 27, 2001 11:09 am**

try the following:

connect Digital Wave Source (software IO)to PulsarAES-EBU Dest (dig). Then delete Digital Wave Source again. NOT A HOAX!
ps: this worked with my Pulsar1 and SPDif. hope it works with aesebu too.
plz reply if it worked...

[ This Message was edited by: Dareinsch on 2001-09-27 12:12 ]

Posted: **Fri Sep 28, 2001 3:37 am**

Thanx man..but still dosen't work..so..I change to 2.04a now..

Jerry
Taiwan

[ This Message was edited by: jhstudio on 2001-09-28 04:37 ]

PlanetZ forums - scopeusers.com

Please help!!No signal from AES/EBU in Win 98SE with V3