DSP loading - Scope & Pulsar
Posted: Thu Jan 28, 2010 3:26 pm
Curious about something. Recently did some housecleaning and reconfiguring of my PC. Everything is working as expected but I was checking out the DSP load window and noted that my Pulsar XTC board is referenced as board 1 and my 14 DSP Scope as board 2. There are a total of 21 DSPs.
Does this sound right? Why isn't the Scope Pro card listed as board #1. The two cards are installed per the instructions with the Scope card on the left and the Pulsar on the right (when viewed from the back panel). Maybe this is all meaningless. I was just curious if this is correct.
Does this sound right? Why isn't the Scope Pro card listed as board #1. The two cards are installed per the instructions with the Scope card on the left and the Pulsar on the right (when viewed from the back panel). Maybe this is all meaningless. I was just curious if this is correct.
