Page 1 of 1
how to set default project loaded upon startup
Posted: Wed Jan 06, 2010 4:30 pm
by doktorfuture
Hi there,
How do I make it so when I start Scope it always loads my default project?
thx
Re: how to set default project loaded upon startup
Posted: Wed Jan 06, 2010 4:41 pm
by cortone
doktorfuture,
Not at my DAW right now, but open the project that you want as default, go to Settings in the menu from the Live Bar, select Projects, and then select Save as Default, and/or Save as New. The wording might be a bit different, but you'll get the idea when you get there. Also, you can set the number of backup files to keep on hand, which is handy, but is probably set to zero right now.
Cheers,
Cory
Re: how to set default project loaded upon startup
Posted: Thu Jan 07, 2010 3:22 am
by fidox
hey,
here's my simple startup project (from this computer) , i have on my main audio computer Scope 5 installed, but same project, cause i want to load scope as fast as possible when winxp starts,
you can load whatever you want and when finished just save as default project and also at win startup,
best,
Matej
Re: how to set default project loaded upon startup
Posted: Thu Jan 07, 2010 7:19 am
by doktorfuture
Super! Thx.