Scope - Cubase Essential 5 Output Bus problem
Posted: Sun Nov 29, 2009 5:58 am
Hey,
why i can't choose more than 8 bus outputs in VST connection ? It worked fine before, i had 16 output ASIO-Scope channels enabled,
in Device Setup - Asio - i can see all 32channels (16stereo), but it shows 16channels active and 16channels inactive,
i have already re-installed Cubase E5 also Scope 5, but all i can add now are 8output channels and not 16 like normal.
then,
i have tried with previous Cubase Essential 4 version, there i can choose/add all 16 channels normally,
does this sounds more Cubase related problem or Scope-Cubase ?
I have already asked 2 days ago at Cubase.net, but nobody answer
anyone had anything similar ?
some facts:
-i was using Cubase Essential 5 and Scope 5 already, so this problem appears yesterday
-Scope 5 - have tried all Asio modules , it's the same
somehow, sounds like formating could solve this, but i really don't want to do that, especally cause version 4 works fine,
best,
matej
why i can't choose more than 8 bus outputs in VST connection ? It worked fine before, i had 16 output ASIO-Scope channels enabled,
in Device Setup - Asio - i can see all 32channels (16stereo), but it shows 16channels active and 16channels inactive,
i have already re-installed Cubase E5 also Scope 5, but all i can add now are 8output channels and not 16 like normal.
then,
i have tried with previous Cubase Essential 4 version, there i can choose/add all 16 channels normally,
does this sounds more Cubase related problem or Scope-Cubase ?
I have already asked 2 days ago at Cubase.net, but nobody answer
anyone had anything similar ?
some facts:
-i was using Cubase Essential 5 and Scope 5 already, so this problem appears yesterday
-Scope 5 - have tried all Asio modules , it's the same
somehow, sounds like formating could solve this, but i really don't want to do that, especally cause version 4 works fine,
best,
matej
