Page 1 of 1
Installing over Scope 4.5
Posted: Sun Aug 02, 2009 8:20 am
by Kymeia
When I installed 4.5 it kept my Scope 4 directory separate and I am still able to run it (though I have no need to). Can I install Scope 5 into a separate directory to and still run Scope 4.5 when I need to?
Re: Installing over Scope 4.5
Posted: Sun Aug 02, 2009 11:40 am
by garyb
no, because 4.5 and 5.0 use a different driver. in fact, you CAN leave the 4.5 folder intact, but you should rename it to avoid program errors...
Re: Installing over Scope 4.5
Posted: Sun Aug 02, 2009 10:30 pm
by rhythmaster
If you have XITE-1, you can run XITE-1 with SCOPE 5.0 and the "old" cards with 4.5 even parallel.
If you have no XITE-1 you can run 5.0 or 4.5 but you have to change the drivers everytime you switch.
You can install both software parallel.
Harry
Re: Installing over Scope 4.5
Posted: Mon Aug 03, 2009 1:10 am
by Kymeia
OK - I'm a bit reluctant to let go of 4.5 thats all - it works so well for me. I suppose the real question is do I need 5? I have most of the plugins including the Timeworks ones and VDAT etc.
Re: Installing over Scope 4.5
Posted: Mon Aug 03, 2009 1:55 am
by rhythmaster
You do not need 5.0 so far.
I have XITE-1 but my projects are in Cubase 5 in XTC-Mode in SCOPE 4.5 and it works fine with my old cards.
XITE-1 is my second leg now and I wait for the first update of SCOPE 5.0 and the official release of XTC - hopefully A.S.A.P. - O.K. after the summer holidays
to begin new with the XITE system and CUBASE in XTC-Mode.
Harry
Re: Installing over Scope 4.5
Posted: Mon Aug 03, 2009 5:32 am
by Kymeia
Thanks - yeah I might as well just hold off then, at least the official release is not out yet anyway.
Is there a list of what is new in Scope 5 compared to 4.5 somewhere? (any plugins or features I would miss?)
Re: Installing over Scope 4.5
Posted: Mon Aug 03, 2009 8:54 am
by garyb
there are a number of new plugins, but really the whole program has been rewritten. functionally, it's pretty much the same as always, but i is better. if you DO use 5.0 right now, be advised that what's currently available is the release candidate, not the final version.
Re: Installing over Scope 4.5
Posted: Mon Aug 03, 2009 2:21 pm
by Kymeia
Yeah I'm aware of that thanks. Although it sounds more like what I would call a late beta really - I work on many software beta programmes and in my experience a "release candidate" should be the finished application that has been sent out for final testing to see if there are any showstoppers. If there are still changes to be made other than in response to late found bugs it is not a "release candidate".