looking for an easy way to check all used CC's in project

[irrelevance]

Is there a way of finding all cc's used across different devices? The only way I know at the moment is to manually open each device's midi ctrl assignment and check what is used/not used, then on to the next device. Would be great if there was a way to find out which cc's are open to use.

[dawman]

I wish.....
I have a Notepad for each project that shows the assignments.
Scope doesn't remember half of them, so I just write them all down.
Once there are re assigned though they work great until another project gets loaded.

[eric]

I also notice you cant assign the same MIDI contoller number to more than one control. That's in Modular 2 anyway.
I guess you just cross-map/remap it in a MIDI processor and send the duplicate control messages on a different controller number - messy.

Eric.

[dawman]

http://forums.planetz.com/viewtopic.php?f=3&t=26759

There's ways around that Brotha' Man Eric.

http://www.spacef-devices.com/dacore/in ... info&id=12

These Dogs Hunt..

[eric]

Downloaded. Will give it a try.

Thanks Jimmy V.

Eric.

[dawman]

They are confusing at first but here's an example.

untitled.JPG

[Neutron]

if you merge everythings midi output and then put a midi monitor on the merged output, it might show them when you reopen the project.

i never tried it though. the reason i think it might is because when i open a project all the pot positions are sent to bcr2000

[irrelevance]

if you merge everythings midi output and then put a midi monitor on the merged output, it might show them when you reopen the project.

i never tried it though. the reason i think it might is because when i open a project all the pot positions are sent to bcr2000

That's a very good idea! I was thinking of ways to somehow trigger devices to spit out the information but you may well be right about the midi output at project load. Will report back!

[irrelevance]

BRILLIANT IT WORKED! So after the project has loaded I can disconnect the midi outs and merger and keep the midi monitor open as a reference to all currently used cc's.
Neutron you are a star...

[irrelevance]

Ok spoke too soon on deleting the connections and merger. On reload the monitor is empty which must have something to do with temporary buffers being cleared. Oh well a merger doesn't cost to much dsp

[Neutron]

cant you copy and paste them in to a notepad? i dont know if midi monitor is copyable, since i never tried.

[irrelevance]

Yes. I just hooked up midi-ox which allows for input monitoring and will copy to clipboard.

[Neutron]

cool, you can use one of spacef notepads to have the info attached to the project.