PlanetZ forums - scopeusers.com

Hy, i install release cubase sx 3.0 original , and running properly-
now i install driver tranzort frontier controller , i see in the sistem try but no interactive for my need.
maybe in the project di scope i configure this device .........
thank in advance .

http://www.frontierdesign.com/Products/ ... pps/Cubase

I don't think it has anything to do with Scope.. USB-devices bypass the Scope-trajectory..

according to that link in your post, you should "Run the basic TranzPort driver installer, connect the USB interface, select ‘Native’ or ‘Mackie Control’ mode depending on the version of Cubase you are using, and the TranzPort is ready to go."
So in Cubase, you should go to "devices" --> "device setup" and click on the + in the upper left corner of that window..

I hope this will help you..
Michiel

i go to "devices" --> "device setup" see icon trasport but no interactive -
i have release 3.1 -
i don't know becouse no run controller