hi,
INSTALLATION tips:
In system 9.0.4 and 9.1
First of all you should have is the latest update installed: 2.042 (it's an update for 2.04a). You can find it on CW/download page.
Trash MULTIPROCESSING folder (found inside the extentions folder - do it manually) - the content of the folder is necessery only if you have dualprocessor mac. The Multiproc... extensions caused slow graphic performance.
After installing the soft - backup the cset.ini file (found inside Pulsar/app/bin folder). It gets corrupted very often so perhaps it is the cause of your crashes. Have it ready to overwrite the original one in emergency.
Read the troubleshooting/tips in your Pulsar manual (it's really helpful but read it carefully)
Install OMS, open Pulsar, make your default settings in Pulsar (ins, outs etc., especially pay attention on MIDI ins/outs), save it as your default project, now open OMS and make your setup.
GENERAL TIPS:
Before turning on your comp - make sure your midi-in device (the one(s) are connected to Pulsar MIDI in) is turned off!!!. Turn the comp on, launch Pulsar.
After loading pulsar, load the OMS app (with your setup, of course) and have it opened to the end of your pulsar session (I mean to the end of your work
. Turn your midi-in device on.
It is essential to have Pulsar and OMS opened BEFORE midi-in device (as somebody said - OMS is no longer updated and causes problems in systems newer than 8.0 ).
Only after these preparations it is safe to launch cubase/logic (just any OMS app). Hope it will help you.
<font size=-1>[ This Message was edited by: samplaire on 2001-08-13 06:45 ]</font>
