PlanetZ forums - scopeusers.com

OK Here's a wierd one. I load up Rotor 48 RD device. "Find Sine Osc RD.mdl" window then appears with the option to select one of two "Sine Osc RD.mdl" files that I have in my Scope directory. Both of these files are identical. Regardless of which one of these two files I then select, the same "Find Sine Osc RD.mdl" window then reappears with the option to select one of the same two "Sine Osc RD.mdl" again. Any ides why I am stuck in the endless loop with the only option to quit Scope and probably then get a BSOD.

UPDATE:- From the "Find Sine Osc RD.mdl" window I selected "Options" then closed the window that appeared. Then I selected "Cancel" from the "Find Sine Osc RD.mdl" window and the Rotor 48 RD device then appeared in Scope and the "Find Sine Osc RD.mdl" window closed. I opened the Rotor 48 RD device and no Sine Osc RD.mdl was loaded into it but I was able to manually insert an Sine Osc RD.mdl into it.

My computer is possessed.

It's the Sine of the Devil.

FWIW, I had a (most likely unrelated) problem with a "missing" DSP message, which ended up being fixed by a permissions change.

-cap