PlanetZ forums - scopeusers.com

I have been sucessfully using my Pulsar2 and Electra cards for many years using the same projest in XTC mode. I had to re-install windows due to a windows config file error. I have re-installed SPF 4.5 and my XTC.pro no longer works. I get a capacity limit error "No DSP Placement" The project works fine in 'normal mode'. I have been through and connected each I/O module in turn. The project fails as soon as I connect anything to Z link dest. I have spent hours and hours trying to solve this problem and am feeling very disheartened...
I have a ASUSP4P800 mobo. The Pulsar is in slot 1 and Electra in slot 5 both share IRQ 21. I am using Cubase 3.1.
Any ideas? Regards
Kenf

Hi,
I have tried the both cards on there own and they both work individually in XTC mode.. but not together when I use the Z link. I re-installed windows with the cards in place do you think it may be worth taking the cards out and re-installing windows. Then the cards one at a time???
Regards
Kenf

try running the Scope installer again(over the top of the old install).
perhaps this will fix whatever file has become corrupted....assuming that file corruption is the problem...

Thanks garyb... I have tried that but will have another go.....
Regards
Kenf

Hi,

Rebuild your XTCproject.pro, some internals might have changed after your re install.

Cheers

yes, good call.

Hi,
Thanks for your help... I have just realised I have been modifing XTC.pro not XTCproject.pro.... What an idiot I am... All works just dandy now... just like it used too.
Regards
Kenf

Thanks again