PlanetZ forums - scopeusers.com

Blue screens unstable clock scope 4.0 quad core

Western Digital Raptor WD1500ADFD 150GB 10,000 RPM Serial ATA150 Hard Drive - OEM

EVGA 512-P3-N841-A3 GeForce 8800GTS (G92) 512MB 256-bit GDDR3 PCI Express 2.0 HDCP Ready SLI Supported Video Card - Retail

CORSAIR 4GB(2 x 2GB) 240-Pin DDR2 SDRAM DDR2 800 (PC2 6400) Dual Channel Kit Desktop Memory Model TWIN2X4096-6400C5 G - Retail

GIGABYTE GA-P35C-DS3R LGA 775 Intel P35 ATX Intel Motherboard - Retail

Rosewill RX950-D-B ATX12V v2.2 & EPS12V v2.91 950W Power Supply - Retail

Intel Core 2 Quad Q6600 Kentsfield 2.4GHz LGA 775 Quad-Core Processor Model BX80562Q6600 - Retail

xp pro 32 bit sp2

Is 4.0 bad on a quad ?

please post a screenshot of your pulsar project.
and:
-when does it happen?
-how often?
-what software do you use?
etc etc
thanks!

GIGABYTE GA-P35C-DS3R LGA 775 Intel P35 ATX Intel Motherboard - Retail

I got blue screens on core2 as well. usually either scope.sys or USB[something].sys

probably due to the fact that board has USB hosts on almost every IRQ its a good board, just not for scope.

try one of the other PCI slots. (how many cards do you have?)

i switched back to the supermicro CS2BE and its been plain sailing!

the intel dp35dp is stable as well, and cheap.

what is sharing an irq with the Scope card?

Ill beback in the studio tommorow I think its in the first slot of three Im pretty sure that is the one that can be on its own
I was recomended this mb on this forum I'm using nue 3 and 2 scope 4.0 lots of N.I synths

are those cracked nuendos or NI synths?

blue screens usually indicate faulty hardware.