PlanetZ forums - scopeusers.com

I was trying these new preset for vectron:
http://www.planetz.com/phpBB2/viewtopic ... 602#217602

but after a couple of days my scope system refuses to load the vectron device!!!
Scope says that (I don't remember well) the DSP must be "reorganized" (or something similar concept), he asks this for 2 times (I press OK) and then the system remains "mute" (also the others devices)... so I must reload a new Scope session!

With vectron player I can load only one voice, if I try to switch to more voices same thing above!

Does anyone knows why this strange behaviour???

Thanks in advance.

Weirdness

I have been doing really neat stuff w/ my newly beloved synth. I have noticed on w/ JBowen's WAVE Oscillators that each waveform has it's own dsp.file attached to it and when I lost just one of those every time I used one of his WAVE Oscillators in any synth, when I approached that empty number to audition it's sound the synths would reak havoc in a similar way.

Maybe the dsp. files are out of wack"......................dunno.

It might be worth a try.



Hope you get it going soon.

Thanks Jimmy for the reply
Sadly nothing is changed... actually I cannot load Vectron and ProTone devices
Maybe some incompatibility with motherboard (PCI bus)...

have ya tried putting the oxe files back in and just reinstalling the instruments.