Page 1 of 1
Posted: Tue Jul 17, 2001 4:56 pm
by tom
Luna now works....and i'm too happy for that....now i need to record some parts from my synth in VST5 but it seems that the connection that i've done in the mixer are not ok...
If someone that use VST5+LunaII could send me a project file or a screenshot of his connection that would be really cool..so i can check if i've wrong somethin' or what....
My address is
sfavey@yahoo.it
Icq: 102206515
Thanks again...
Posted: Tue Jul 17, 2001 5:17 pm
by subhuman
First, load up the ASIO source and destination modules. Then, route audio from Pulsar to the ASIO destination -- once inside the Cubase Mixer, you'll need to "record enable" each channel -- that's it!
To get audio out of Cubase, simply route signals from the ASIO source to your hardware destination like "Luna ANalog Destination."
Post here if you still need something, remember the Manual can be a great help when first starting
Posted: Tue Jul 17, 2001 6:02 pm
by tom
Mhmm....i get the sounds...but..maybe i've to activate some BUS in the VST Master and/or in the VST Mixer?
Check your mail...
Thanks again!
*B*
Posted: Wed Jul 18, 2001 7:30 am
by subhuman
Yeah you're close, try using the AUX on the recording mixer connected to ASIO destination, then you can select channel send levels. Alternatively, simply route the Main L&R outputs to ASIO 1&2, and mute everything you DONT want to record (might be easier when first starting)