PlanetZ forums - scopeusers.com

Hello hello. I run Pulsar II on A MAC G4.
and I use VST 5.
I have tried to connect all my samplers and synths in Pulsar directly to ASIO.
(dont use a big or dynamixer)
and in VST 5 I make shure I have Creamware as asiodriver.
but then..I MUST record enable EVERY channel to hear the sounds from pulsar ????. is there any other way.
this taking cpu from Cubase VST.

and i also must record enable everything again, it dosent save with the song

please please anyone

Why in the hell are you not using a mixer?

must I have a mixer in pulsar first
when I wanna use the Cubase VST mixer for the mix ??????.
its seems like mixers on mixers.
if pulsar mixer must be connected.

I thought I directly could connect
the devices to the asio so they reach the VST mixer!!.. and they do but I think the problem is in VST. because everything works in a kind of way, and my synths sounds from the cubase VST mixer. (use 16 channels asio)
so THERE is my mixer.
But still !!!.....like a first posted.
must I record enable the Cubase VST mixer to hear the sound from pulsar

Hi. You don't have to rec. enable the mixer ch. to hear them. You are using the wrong channels. I know it can be done. The thing is i use Logic so i'm not sure how. But i've read that other Cubase users do it that way. I do it as well but as i said in Logic.

Thanks jupiter, then there is a way...
hmmm.
got to find out !!!!!

input monitoring. somewhere there's a switch or preference.unfortunately i also use logic or i'd tell you where to look.