Page 1 of 1
Installing Scope
Posted: Mon Jan 21, 2008 7:21 am
by t_tangent
I have just sold my pulsar 1 card which has Scope 4.0 registration. In order to provide the buyer with some basic help in setting it up I was wondering if he will need to install Scope 4.0 first and then upgrade to 4.5 after or can he just install 4.5 without needing 4.0 at all. I cant remember off hand, so any help would be appreciated. Thanks
Posted: Mon Jan 21, 2008 7:59 am
by the19thbear
you dont need 4.0
just go ahead with 4.5
Posted: Mon Jan 21, 2008 8:44 am
by t_tangent
Thanks 19th bear
I will pass that info on.
I also have referred this forum to the chap for future info and assistance
Cheers again
Posted: Mon Jan 21, 2008 12:23 pm
by t_tangent
Thanks stardust, yes I think he intends to get the synth & sampler pack for it amongst others. I think I did recommend him to use 4.5 so I'll make sure I reiterate that
Cheers