Page 1 of 1
Found the problem
Posted: Tue Jan 08, 2008 10:36 pm
by mausmuso
Hi there,
I got Reaper working.
It was pretty obvious but there ya go.
I had not unclicked the "Allow projects to override device sample rate" on the bottom of the Audio Devices page.
Of course SCOPE must set the samplerate and (in my case at least) any request by Reaper to do so made Reaper crash.
Hope this helps any one trying to get things up and running.
Regards
mausmuso
Posted: Tue Jan 08, 2008 10:44 pm
by garyb
Posted: Wed Jan 09, 2008 6:02 am
by Shroomz~>
Tips & tricks forum? Just kidding mausmuso.
Glad you figured it out.
Posted: Thu Jan 10, 2008 3:28 am
by the19thbear
do you use reaper in xtc mode??? i cant get it working!
When it detects the scope plugins, the blue "choose scope hardware" ( the one where you have to improt keys etc..) box pops up.. but for somew weird reason there is no hardware to choose! so.. according to reaper i have no scope card when i use xtc mode!?
it works fine in sfp mode.
thanks alot!
Posted: Thu Jan 10, 2008 5:10 am
by alfonso
the19thbear wrote:do you use reaper in xtc mode??? i cant get it working!
When it detects the scope plugins, the blue "choose scope hardware" ( the one where you have to improt keys etc..) box pops up.. but for somew weird reason there is no hardware to choose! so.. according to reaper i have no scope card when i use xtc mode!?
it works fine in sfp mode.
thanks alot!
I don't use XTC but do you have it enabled in the Scope "Settings"?
Posted: Thu Jan 10, 2008 5:17 am
by the19thbear
yes i have...
works fine in cubase sfp mode!!
Posted: Thu Jan 10, 2008 9:55 am
by garyb
who needs xtc mode?
