PlanetZ forums - scopeusers.com

Hey folks, I've got a very stupid question about something I have been ignoring for way too long. Okay, here it is:

I have a 19inch monitor. When I view the pulsar bigmixer in 800 x 600, the bigmixer is too big for the screen. When I view it in 1024 x 768 it is a bit too small and hard on the eyes. Is there anyway to compromise the two and make the bigmixer fit exactly in the screen? What am I doing wrong? I feel like I am not using my monitor space efficiently. Thanx in advance fellas... sorry for the lame question.

RL

Well the software ask's for 1024/768
I run my setup at 1600/1200 on a 19inch and I still wish I had more room



Cheers
Paul

If you install pulsar with your display set to 800x600, then change your display to the 1024x768 the entire pulsar gui appears smaller than your monitors total display area. Is that the problem you're having?

i had exactly the same problem!..the only way i could fix, was to uninstall, change the screen size to you prefered size, the re-install the software...

there is a small display of the screen under settings in Pulsar OS. move the edges around and see if it works

instead of reinstalling, check my (still young and growing... feel free to PM or email to help it along) <a href=http://www.infinitevortex.com/default.a ... >Creamware FAQ</a>...

_________________
fall into the <a href=http://infinitevortex.com>infinitevortex</a>

<font size=-1>[ This Message was edited by: subhuman on 2001-07-09 09:34 ]</font>