PlanetZ forums - scopeusers.com

OK, so hopefully this isn't too stupid a question, but I can't seem to figure out for the life of me (or find in the manual) how to change presets when in MULTI mode. Whenever I throw a preset change message at Noah, it changes only the presets in the respective slots of a Multi Performance, not the overall preset number of the Multi performance.

This would seem a pretty basic feature and I'm sure I'm not doing something right, so any help would be greatly appreciated.

You must change the program in the general channel that basically is the mixer's channel.
Obviously the reload of synths is slower than a preset change on the same synth...

That certainly did the trick, thanks! I saw my Noah's mixer channel is set to 16 and sure enough, preset changes sent on channel 16 change the Performance presets (though a bit slowly, as you mentioned). Thank you so much!

It is slow, but not so much as the redraw though....