PlanetZ forums - scopeusers.com

Hi all!

Is there any possibility to monitoring a signal with this mixer?
I'd like to route a synth to the mixer's input. The output signal to record
would be routed to cubase using asio modules and the monitoring signal
would be routed to the pulsar analog out... I see that ths STM 2448
has StdL and StdR outputs for monitoring but I have 6 dsp only... but I will try...

Is there any nice possibility to preamp a signal? I see the 2448 has
a pre-amp for each channel.

Is the channel fader the only way to amplify a signal in 1632?

Many thanks.

Cheerz.


Gius.

you could use a channel module or other small control modules for additive volume control, there are also SDK versions

If you need a gain stage, try
http://www.planetz.com/forums/viewtopic.php?t=18502