Page 1 of 1
Hardware test
Posted: Fri Jul 13, 2007 7:53 am
by Cochise
How can I perform an hardware test for my CW boards?
Posted: Fri Jul 13, 2007 10:48 am
by Cochise
No problem when I change latency or samplerate.
I instead have problems if I reach DSPs capacity limit. If, trying to increment the voice number, i've a run out of DSP, then though lowering the voice number i often get strange behavior. (But of course there's some unstability even without reaching DSPs capacity limit)
Posted: Fri Jul 13, 2007 10:58 am
by Shroomz~>
It's always worth trying a reset in the form of switching once between Master & Slave or vice versa in the Samplerate window. This can resolve system problems which occur occasionally after dsp capacity limit reached errors. Thanks to Astro for that top tip
Posted: Sat Jul 14, 2007 6:51 am
by Cochise
Thx mates.