PlanetZ forums - scopeusers.com

hullo!
anyone interested in joining Shayne's sdk manual project? The sdk dg forum is open..As Shayne said:

Perhaps we can get it going at last!

I had posted some ideas over there but am feeling a bit lonesome...

I had registered some time ago, but never got activated....
as far as I know.

to activate your account, you have to drop Ralf or Holger a mail.

Hi there,

don't dispair about the documentation forum. I've been a member for a couple of months now & check in once a week to see if there's any action, but... there isn't.

I'll post a reply over there so you don't feel tooo lonely Roy

btw, I think that the help of one of the original platform devs would be needed to be able to do a really thorough job of this project. There's no point in producing documentation that's flawed because of lack of knowledge on our parts'. For example, I only just read it a couple of weeks ago & no offense to Shayne, but some of the important sections of the 1st time use doc are incomplete (preset handling for example).

regards,
S

thanks for the reply shroomz. feeling still lonesome sdk dg - wise though.
Nevertheless I added some more pdf files about curves and two lists of the available sdk Modules.
Just to sort it out what's in stock.

I was just busy adding preset handling to those Blue Series drum modules. That way your website doesn't have to say 'not preset compatable' next to each module.

Yeah, I'm sorry I kinda flaked out again. I started writing another chapter for the manual a couple of months ago but realized that I'm not that much of an expert on the SDK. I wish we did have a couple of more knowledgeable people around to help us along.

I could try to finish up the chapter I started writing...it's sort of an easier-to-understand replacement for the "Scope Paradigm" chapter that we already have.

Shayne

I honestly don't know what happened a couple of years back when it went pear shaped. Anyway, it's cool that your still up for it!!