PlanetZ forums - scopeusers.com

Hi,

I been trying firstly to see if there was a solution on this forum, but i cannot find one specific to my problem.

Problem:

I am trying to route my ADAT I/O from my Yamaha 01v96 into Cubase SX3 through the Pulsar II ADAT I/O.

I can't register any sound from hardware synths that go through the 01v96 mixer and onto Cubase mixer via ADAT so i can record it or use FX. I can get pulsar synths to sound onto my monitors from Pulsar ADAT onto 01v96 mixer.

Can anyone help me via pictures or some site to see where the breakdown is happening, if its Cubase, the 01v96, or something in the Pulsar II routing.

Thanks in advance.

So in the scope routing window you have ADAT Source going to ASIO Dest to get into cubase? Try putting a mixer/meter across ADAT Source to make sure you are getting a signal into scope.

I found what the problem was.. i never clicked on the monitor button on the cubase mixer...

exactly that I had in mind, but you figured it out already
(new to SX3 too ).