PlanetZ forums - scopeusers.com

I just cleanly reinstalled Gigastudio160 v2.54 on my PC due to some problem.
My PC has Luna2 + Pulsar2 cards and MOTU2408MKII audio interfaces.
The problem is that when I select the "Scope/Pulsar Multichannel Driver [Card 1]" on the Gigastudio Hardware/Routing, all the Outputs Enabled columns were disabled.
It wasn't like that before I reinstalled the Gigastudio, I was able to enable all 32 outputs there.
Anybody know the reason?
Thanks.

hc.

Oh I am sorry I didn't realize that I was in xtc mode, instead of the scope mode.
Now I am able to enable all the 32 outputs in Gigastudio using the scope mode, however I am still having problem that only output 1 & 2 are working the rest ouputs have no signal.
I have routed 32 GSIF outputs to the scope mixer in the routing windows, but only 1 & 2 are working.
Anybody can help me?
Thanks.

hc.