PlanetZ forums - scopeusers.com

i have a cme uf7.
i have problems when i assign knobs to some creamware synths.
for example prisma seems not to be able to get the singal. sometimes it works.
lightwave the same today. the controller settings windo shows that the learn is ok, but after nothing moves to the synth.
someone told me to make a permanent setting that loads with the synth automatically(midi preset) including all the settings i like, only through SDK.
anyway.... is there a way to make things easier?

god i need hardware.....................

I've got a CME U7. Are you using the midi out from the U7 into Scope midi or are you using the USB and routing through a sequencer?
Using the midi connection I have no problems with the U7 CC controllers (both knobs & sliders) controlling scope devices.
The USB connection - not so good. I only use it for the sequencer control buttons - they won't transmit over midi.

/dave

thanks dbmac.
i already work the way you work.
midi for scope and usb for nuendo seq buttons.

i fixed it by reloading the project again.
f.... pcs

I also have to occasionally reset (off/on switch) the U7 to fix some midi note off wierdness.
Don't do this if the U7 is connected to USB - instant PC shut down.

/dave