PlanetZ forums - scopeusers.com

Posted: **Wed Nov 08, 2006 6:03 am**

I'm having some serious problems installing Scope 4.0.
After running thru the processes of entering the keys etc, I click next and then all the files seem to be installed, but it doesn't get to a point where I can click finish or whatsoever.
It just stays the way it is, all I can do is click cancel, but this doesn't finish the installation.

The same problem I'm having with Scope 3.1 as well.
That's why I went back all the way to Pulsar 3.0, which does install.

Btw, I have a Pulsar 1 card.

Is there anything I could do to solve this?

Posted: **Wed Nov 08, 2006 9:06 am**

Wich OS do you use?

Posted: **Wed Nov 08, 2006 4:03 pm**

XP home

Posted: **Wed Nov 08, 2006 4:14 pm**

how long are you waiting for it to say finished?

does scope start after?
this sounds like a system problem.....

Posted: **Thu Nov 09, 2006 6:20 am**

No finish pops up at all, it just stays there with the whole bar turned blue.
All I can do is cancel, and after that there's nothing installed from Scope 4.0

Posted: **Thu Nov 09, 2006 6:48 am**

you could check the card's fitting in the PCI slot

Posted: **Thu Nov 09, 2006 9:46 am**

always a good idea, hubird.

exactly how long do you wait with the bar staying blue before you cancel?

PlanetZ forums - scopeusers.com

Can't install Scope 4.0

Can't install Scope 4.0