PlanetZ forums - scopeusers.com

hI,
Can two pulsar II and one Pulsar I coexist WITHOUT any problem on same computer ?
ULLI asio anyway is 25 ms so no latency problem here.
I know pulsar I has only one leg for stdm connection, maybe that could cause some problem, or ?
I will mainly use Pulsar I for I/O purposes.
Regards,
Dimitrios

There should be no problem mixing type 1 and type 2 pulsars

for ULLI make sure Pulsar II is #1and always in command this way you can get the lower latency of the pulsar 2

Currently running PowerPulsar (15 DSP) + Pulsar Pro I (4 DSP) + Pulsar I SRB (4 DSP) with ULLI set @ 7 ms (44.1 Khz) and everything works blissfully!
Other than having to slightly twist the STDM cable a little to manuver from the 2nd generation card to the 1st generation ones (since the location of the bus connectors is slightly different), they work in perfect harmony.