Page 1 of 1
Posted: Sun Oct 15, 2006 11:49 am
by Fluxpod
I cant get the routing from, cubase to my Pulsar1 to work i use the normal asio source into the mixer it playes in cubase and the routing there seems ok too but no sound is reaching the creamware mixer...any suggestions?
Posted: Sun Oct 15, 2006 12:05 pm
by Fluxpod
I am usind sx 3 and scope 4.0 btw and its driving me nuts
Posted: Sun Oct 15, 2006 12:17 pm
by Fluxpod
Yes the driver is creamware asio
The vst connections are correct
The monitor listening butttons are pressed
It plays in cubase and showing the signal but its not going into the creamware mixer:( iam out of ideas:/
Posted: Sun Oct 15, 2006 12:29 pm
by Fluxpod
may a reinstall will solve it? I already reinstalled cubase...may i have to reinstall scope too??
Posted: Sun Oct 15, 2006 12:37 pm
by garyb
you did have the asio modules in place before opening cubase, correct?
it must work if set up properly.
Posted: Sun Oct 15, 2006 12:42 pm
by Fluxpod
OMG man im just an idiot i forgot to install xtc mode...working now:D Btw nice forum here.