Page 1 of 1
Posted: Thu Oct 12, 2006 2:37 pm
by Fluxpod
I cant select latency´s below 13 ms@44.1 it says your hardware doesnt support it...Why?
Posted: Thu Oct 12, 2006 2:52 pm
by ali
board 1 don't go below that.
you can go lower only if you add a second generation board (luna/pulsar2)
Ultra Low Latency only available in 2nd generation boards.
Posted: Thu Oct 12, 2006 2:55 pm
by Fluxpod
Thx mate.
Posted: Thu Oct 12, 2006 8:32 pm
by Shayne White
Pulsar 1 can go below 13ms latency *if* you have an additional 2nd generation board and it's set to be the master board and handle the interfacing. But again, you need a 2nd generation board. Pulsar 1 on its own can't handle the faster speed (it's from 1999, and ASIO was really new and everything...personal computers could barely handle low latency in those days!!).
Posted: Fri Oct 13, 2006 2:36 am
by Nestor
I own a Pulsar I, and despite the fact it can only go to 13ms, latensy is still not a problem for me, at all in fact.
Posted: Fri Oct 13, 2006 3:44 am
by erminardi
On 2006-10-12 21:32, Shayne White wrote:
Pulsar 1 can go below 13ms latency *if* you have an additional 2nd generation board and it's set to be the master board and handle the interfacing. But again, you need a 2nd generation board. Pulsar 1 on its own can't handle the faster speed (it's from 1999, and ASIO was really new and everything...personal computers could barely handle low latency in those days!!).
You mean that if I couple a Pulsar1 with a 2nd generation board I can achieve a low latency output not only in the 2nd generation card I/O but even in the Pulsar1 I/O???
Wow!
I thougt the Pulsar1 I/O was unusable at ULLI latency.
Very nice
Thanks, I will try...
I actually use my Pulsar1 as DSP addition... a couple of additional I/O are welcome
<font size=-1>[ This Message was edited by: erminardi on 2006-10-13 04:51 ]</font>