Page 1 of 1
Posted: Wed Sep 27, 2006 1:50 am
by bcslaam
Hi
I have a Plus daughterboard with both the balanced and unbalanced cable assemblies and a sync plate that i'm willing to swap for an adat expansion that will fit to my scope pro, p1 or p2.
Posted: Wed Oct 04, 2006 5:18 pm
by Spiff
I have the Pulsar 2 daughterboard with the two adat interfaces. That's the one you're looking for, right? I might be interested in swaping this one.
Before we consider it, we should check revisions of the pulsar boards. I just had to find out that I'm not able to have my luna 2496 breakout box on any of my pulsar cards.
Anyways, let me know, if you're interested.
Posted: Fri Oct 06, 2006 8:01 am
by musurgio
Hi,
You mean you are giving the plus cable extension (XLR etc) plus the sunc plate for a ADAT addon board for scope right ?
Regards,
Dimitrios
Posted: Fri Oct 06, 2006 7:21 pm
by bcslaam
Hello sorry I have been on holiday.
Hi Spiff
I think the pulsar daughter board with 2 adat interfaces is the one i already have. It would have a d sub connector on it aswell for the cable asembly. Unless we have our wires crossed and you are talking about the extra board that connects to the dsp plugs. I think there is also a daughter board with 3 sets of adat i/o but i have never seen it. Anyway maybe you could further describe the nature of your board and I will check my revisions.
Hi Musurgio
Yes that is correct.
Posted: Mon Oct 16, 2006 10:58 am
by musurgio
Hi,
Deal.
I will trade my 24 adat addon interface for your classic plus sync plate.
Let me know
Regards,
Dimitrios