Page 1 of 1
Posted: Tue Sep 19, 2006 6:05 pm
by braincell
I looked under hardware and software modules and I can not find the syncplate module. Where can I get this? Thanks.
Posted: Wed Sep 20, 2006 2:37 am
by voidar
Mine are located under MISC.
Posted: Wed Sep 20, 2006 3:29 am
by valis
Mine are under "Tools" (4.0)
Depending on what sort of sync you're using, you might want to look at ASIO2 drivers (dest module has Clk).
Posted: Wed Sep 20, 2006 2:42 pm
by braincell
I want to sync the VDAT to external word clock. I noticed it works better with external wordclock as the master to my cards but I am not yet using the sync modules. Will this make it better? I am on the edge of being able to use the VDAT with my large project. Sometimes it works and sometimes crashes. I can not load my project so I have to partly build it. This is because of not enough DSP chips and not enough CPU overhead.
Posted: Wed Sep 20, 2006 2:57 pm
by garyb
afaik, if scope is synced to the external clock, so is vdat automatically. you would use the syncplate module to use a brc. you would then need to connect the external clock to the brc...