Page 1 of 1
Posted: Sun Sep 03, 2006 2:41 pm
by paulrmartin
I checked my environment in Logic, all the right connections are there. I have been using the SAME Scope Project for YEARS and this is a revolting new development. MIDI does work in that blasted Cubase but I will not switch!(so don't mention it, ok?)
The only thing that is new in my computer is a new HD with a second raid controller (because it's my 3rd SATA HD).
Please help
Oh yeah, I did the win.ini thing as well
_________________
Are we listening?..
<font size=-1>[ This Message was edited by: paulrmartin on 2006-09-11 14:38 ]</font>
Posted: Sun Sep 03, 2006 4:47 pm
by paulrmartin
Never mind. I think I scared my cards by clicking "Enable XTC mode" and unchecking it...
I have no idea why it suddenly came back...
Posted: Sun Sep 03, 2006 5:19 pm
by hubird
just bad luck Paul
(you could ad 'solved' to the subject...
).
Posted: Sun Sep 03, 2006 6:30 pm
by paulrmartin
You're absolutely right, Huub
Done!
Posted: Sun Sep 03, 2006 9:51 pm
by valis
for future reference Logic enables/disables its midi ports in the [Logic] section of C:WINDOWSwin.ini
Posted: Mon Sep 04, 2006 6:13 am
by paulrmartin
On 2006-09-03 15:41, paulrmartin wrote:
Oh yeah, I did the win.ini thing as well
Posted: Mon Sep 04, 2006 9:44 am
by valis
lol. /me wakes up.
Posted: Sun Sep 10, 2006 9:19 am
by paulrmartin
Ok. MIDI is not going into Logic at all.
I am starting to think it has something to do with me srewing up my second raid controller(I had a third SATA drive installed so I needed another RAID controller).
Is that possible?
Posted: Sun Sep 10, 2006 10:18 pm
by valis
Scope sees midi input (in midi monitor)? This is routed to a sequencer destination that is available in logic, but not being 'seen'? Did you go to the clicks & ports layer in the environment and attach a monitor directly to the input there to see if Logic overall is getting data?
Posted: Mon Sep 11, 2006 2:37 am
by paulrmartin
Logic is not receiving anything as far as MIDI is concerned. My environment(clicks and ports) is configured correctly.
Posted: Mon Sep 11, 2006 12:58 pm
by valis
Are any other apps able to recieve midi (midi-ox for instance)?
Posted: Mon Sep 11, 2006 1:38 pm
by paulrmartin
I added a second Sequncer Destination to my Scope project and MIDI goes to Logic fine now....
Go figure....