Page 1 of 1
Posted: Mon Aug 14, 2006 6:02 pm
by vulkin
Greetings.
I am happy with my current setup of Cubase running through an MLAN audio card. I just got a Scope Professional card, and want to use it purely as a dsp, like I do with my UAD card. How do I do this?
Thanks in advance
Richard
Posted: Tue Aug 15, 2006 12:02 am
by voidar
Posted: Tue Aug 15, 2006 7:44 am
by vulkin
So i can in theory just do it in XTC mode. Great. Here's the problem.. I'm confused. (Surprise, right!) I can't quite figure out how to configure the xtc.pro settings. Cubase sees all the plugins, but when I go to instantiate one, I get a 'xtc plugin not properly configured' and the fx don't do anything and the synths don't either. I've tried with the manuals but am clearly missing something elementary. Any cheat sheets available for this?
Posted: Tue Aug 15, 2006 9:31 am
by okantah
you must closed sfp when in xtc mode just simple.
cheers
Posted: Tue Aug 15, 2006 9:34 am
by vulkin
Zem
I think the problem ultimately is that my xtc.pro file may be incorrect. Because I'm using IO from my mlan, and nobody else seems to do that, I'm not sure what the xtc configuration should be. Any ideas on what the .pro should look like to use xtc mode with no Scope IO?
Posted: Tue Aug 15, 2006 12:27 pm
by garyb
you do need to remove the i/o from the card and install a plug(defeater key)onto the connector for the i/o daughter card afaik.
Posted: Tue Aug 15, 2006 12:55 pm
by vulkin
I think I have a better idea... sort of. I'm going to use the i/o from the Creamware card. That should make things easier.
More as I figure this out better!
Posted: Tue Aug 15, 2006 1:10 pm
by samplaire
On 2006-08-15 13:55, vulkin wrote:
I'm going to use the i/o from the Creamware card
Good idea! They are very good sounding!