PlanetZ forums - scopeusers.com

Help!

I can not make the NOAH ASIO driver work on my lap top running Cubase SE3 and XP Professional. The wav driver is fine, so the USB chain allows for communication between computer and NOAH. Noah ASIO is available in the Device manager, and latency is calculated, but if i run a VST instrument, no sound ...
Also in Wavelab, all drivers work fine apart from the NOAH ASIO.

I did install ASIO4ALL a while ago. Selecting NOAH as default device from A4A setup worked, but the latency was 29ms and it was all out of sync. So i removed the A4A from my machine.

The NOAH Asio did not work as long as A4A was installed, and does not work after the removal of A4A either.

Anyone? I am desperate.

Neb

asio4all probably overwrote something in the registry. maybe a reinstall or the noah software and maybe even se3 would help(over the top of the old installs. hopefully that will help overwrite potential problems.

as to the vsti not making sound, are you getting sound out of cubase at all? vstis play inside cubase, so if you get sound out of cubase and you use a vsti, the vsti MUST make sound...IF it's midi source and the asio output are properly configured for it's track...

When I use NOAH ASIO module, Cubase is completely mute. The Midi-chain works fine by the way. I receive midi from "USB unit" and output the midi signal to the selected VSTi. But no sound. All VST ins and Outs are configured to NOAH USB module.

I did get sound from Cubase when running A4A and Noah at the same time, but latency was to high and when recording several tracks, everything was out of sync, which is why I desperately try to make NOAH ASIO work.

Do you know how I can completely remove every trace of A4A, and do you know how i can freshly re-install the NOAH drivers?

Nab

are you using the "asionoah" driver in cubase? also, i'm sure that you know that you need to have the noah's asio driver available BEFORE opening cubase, right?