Posted: Wed Jul 26, 2006 9:14 am
Hi all
I have noticed, on using Wavelab visual analysis, that I have a rumble at 0-20 Hz, off my P2 and SRB cards... incoming files from other systems do not have this, only ones processed via Scope.
Should I just stick a high pass on all the outputs from CW (or when in Wavelab etc), or does anyone know whey this is happening?
I record back from Scope into Live 5 or Sonar. Same whichever.
Image is at
http://www.ecotist.com/scope.jpg
This is a bassline only. No actual 20Hz content as it is a sample playback so not a synthesis artefact, also it is an all files.
It appears to follow the amplitude, not sure what that is all about?
Thanks
Geoff
<font size=-1>[ This Message was edited by: geoffd99 on 2006-07-26 10:15 ]</font>
I have noticed, on using Wavelab visual analysis, that I have a rumble at 0-20 Hz, off my P2 and SRB cards... incoming files from other systems do not have this, only ones processed via Scope.
Should I just stick a high pass on all the outputs from CW (or when in Wavelab etc), or does anyone know whey this is happening?
I record back from Scope into Live 5 or Sonar. Same whichever.
Image is at
http://www.ecotist.com/scope.jpg
This is a bassline only. No actual 20Hz content as it is a sample playback so not a synthesis artefact, also it is an all files.
It appears to follow the amplitude, not sure what that is all about?
Thanks
Geoff
<font size=-1>[ This Message was edited by: geoffd99 on 2006-07-26 10:15 ]</font>