Page 1 of 1

Posted: Fri Jul 07, 2006 9:34 am
by H-Rave
Has anyboy noticed a high pitched noise when you connect an adat source into the mixer on a pulsar 2 classic, without a converter connected.I only have it one channel.is this normal ?Do I need to clean the contacts any comments would be gratefully appreciated.
Richard Hargrave

<font size=-1>[ This Message was edited by: H-Rave on 2006-07-07 10:35 ]</font>

Posted: Fri Jul 07, 2006 11:58 am
by garyb
no, but it's useless with no converter connected. i'd guess that's normal.

Posted: Fri Jul 07, 2006 11:45 pm
by H-Rave
Yep,I think your your right gary.Let it drop a silly question anyway I suppose.I was going to buy an ADA8000.I'll ask again later when It's connected.
Thanks
Richard Hargrave

Posted: Sat Jul 08, 2006 12:46 am
by at0m
You can test by connecting the ADAT in to ADAT out of your card...